Course headings of reinforced concrete structures design course:
Preliminary course:
Familiarization with commonly used AutoCAD commands
The initial shooting of the floors based on the architectural plan
Understanding seismic systems and choosing the right system
Creating a new file in ETABS software
Defining the geometry of complex structures in ETABS
Definition of materials – concrete cross-section and common roofs based on regulatory and executive restrictions
Allocation of sections and ceilings
Fix software errors during drawing
Definition of end rigid regions and rigid and semi-rigid diaphragm
Introduction of cracking coefficients in different situations
Definition and application of surface and linear dead loads according to the sixth topic of the new edition along with the review of implementation details
Interpretation, definition and application of surface and linear live loads according to the sixth topic of the new edition
Interpretation, definition and application of earthquake vertical loads
Interpretation, definition and application of Mass
Examining the by-laws clause of the modeling of the barn
Applying the point load of the effective seismic weight of the truss
Interpretation and partition load states
Interpretation, calculation and application of earthquake coefficient based on 2800 regulations
Interpretation and calculation of dynamic earthquake and introduction of earthquake spectra
Interpretation of snow load and conditions of its application
Interpreting regulations and creating load combinations in different situations
Analysis settings of pi-delta coefficients according to regulations
Investigation of twisting irregularity and fines of the regulations and tricks of not considering the fines of the regulations
Controlling the number of oscillation modes, and checking the spectral analysis requirements
Co-basing dynamic base cut with equivalent static
Examining and interpreting the uncertain coefficient and the conditions of its application according to the regulations
Choosing regulations and applying its coefficients
Designing beams and controlling the results manually based on the new regulation of topic 9
Designing the columns and controlling the results manually based on the regulations of the new topic 9
Interpretation of design results
Relative lateral displacement control and control tricks
Thermal analysis
Review of other regulatory controls
Section optimization
Preparation of map outputs and preparation of calculation notebooks
Parno software training, drawing and documenting structural maps
Advanced course:
Retaining wall modeling, calculating and assigning soil pressure to retaining walls
Retaining wall design
Implementation considerations of beams buried in concrete walls
Optimization and typing of linear elements
Modeling, shear wall meshing
Investigating the cracking condition of the walls
Shear wall design and analysis of design results
Openable shear wall design
Modeling and design of structural ramps
Concrete slab roof modeling and loading
Regulatory settings and controls
Roof riser control
Design of ceiling reinforcements
Punch cutting control in flat slab
To see examples of completed projects and participate in this course, touch the links below