UPS for medical equipment

UPS for medical equipment

UPS for medical equipment today, technology is the main and important part in the treatment sector.

All types of ultrasound devices, equipment in the ICU and CCU resuscitation rooms and highly advanced laboratory equipment, MRI, CT scan and X-ray imaging devices are only a part of the advanced medical and laboratory equipment that is available in all clinics. There are hospitals.

All these equipments require alternating current and high voltage quality and minimum pseudo-sinusoidal or step oscillation. Due to the technological advances, the electricity consumption of these devices has been greatly reduced today, and most of them are used with a power below 10,000 volts and amps, but with This presence of electricity consumed by the laboratory or photography unit may be industrial and three-phase electricity, which is often the case.

However, these devices are very expensive and the slightest damage to it requires expensive repairs. In addition, errors in the operation of these devices endanger the lives of patients undergoing treatment and testing.

The input power to these devices must be of the highest quality. Power frequency changes should be less than 0.5% and the voltage drop during device operation should be negligible and less than 3%.
The best and perhaps the only suitable method to meet these needs is to use a UPS.

Interactive online UPS with a power of 10,000 volt amps are very suitable for hospital equipment.

The purpose of using UPS for hospital equipment is to provide emergency power, reduce noise and eliminate power fluctuations, increase the quality of alternating current, supply power during peak consumption and prevent overloading of wiring.

UPS power required for medical and hospital equipment

Small to large laboratories require between 10 and 25 kilowatts of electrical energy to operate. UPS for medical equipment
It rarely happens that all the equipment works together, but anyway, the power distribution defined for the design of the laboratory should be defined as the same value.

Since the input power is defined in the industrial power laboratory, an industrial UPS unit can also be used and easily charged by the input power.

Depending on the availability of continuous urban electricity and the degree of reliability and risk of power outage, batteries with a storage capacity of 3 to 88 hours are used. .

Another method is to use single-phase UPS for each device separately. This mode is more suitable when the power input to the equipment room is single-phase. Nowadays, there are both single-phase and three-phase electricity in many hospitals.
source upsonline.ir

⏪ Medical equipment repair training channel, Academic Jihad, Tehran Medical Sciences Unit
@BME_jahad

This post is written by alimahmoudii